2004 Ford Transit

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) wearing thin pads very low (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive rear crossmember corroded (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill has corrosion (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear inner and outer sill corroded (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear crossmember corroded (5.3.6 (a) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) wearing thin pads very low (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive rear crossmember corroded (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill has corrosion (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both front inner arches have corrosion (5.3.6 (a) (i))

Rear Prop shaft joint worn, but not excessively rear center prop bearing joint worn (6.1.7 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive under side has corrosion (5.3.6 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Position lamp adversely affected by the operation of another lamp illuminating when foot brake pressed (4.2.3 (c))

Nearside Front Anti-lock braking system wheel speed sensor excessively damaged (1.6 (c))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Registration plate inscription illegible (0.1 (b))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis leg outer side (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis leg outer side (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

underbody surface corroded

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Headlamp has a product on the lens so that the light output is severely reduced both (4.1.4 (b))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

underbody surface corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.2.2 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.2.2 (a) (i))

o/s/r tyre perishing

slight engine oil leak

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

front brake discs lipped, look low

n/s/f inner brake pad on the limit

o/s/r tyre perishing

slight engine oil leak

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Offside Front Nail in tyre ()

Offside Front tyre wearing on inner edges

oil leak from n/s/r brake drum

nsf tyre slight cut on outer wall but cords not showing

nsr light slighty cracked