2005 Ford Transit Connect

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front body sill corroded

Oil leak, but not excessive engine (8.4.1 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced body sill corroded (7.1.1 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength body sill corroded (5.3.6 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front body sill corroded

Offside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Front outer sill holed

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Driver's door hinge deteriorated but the door can still be readily opened and closed (6.2.3 (c) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

both outer sills slightly weakened by corrosion

engine lower rear mount/stabilizer excessively worn

rear/mid exhaust rubber missing but system still supported well

slight leak of oil or other fluid from engine area,possisbly residue from old leak

Brake pedal anti-slip provision worn smooth (1.1.2 (c))

Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Position lamp not working (4.2.1 (a))

Oil leaking excessively from engine (8.4.1 (a) (i))

Windscreen washer not working (3.5 (a))

Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected both outer sills (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front outer sill holed

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Driver's door hinge deteriorated but the door can still be readily opened and closed (6.2.3 (c) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

both front to rear and both rear brake pipes corroded

engine lower rear mount/stabilizer excessively worn

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Nearside Front Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear brake binding slightly

Central Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested due to exhaust condition (7.4.B.1)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear brake binding (3.7.B.1)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working both (1.1.C.1d)

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Inner Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear Brake pipe slightly corroded both (3.6.B.2c)

Nearside Front Anti-roll bar linkage fractured (2.4.G.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Inner Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear Brake pipe slightly corroded both (3.6.B.2c)

Nearside Front Anti-roll bar linkage fractured (2.4.G.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Inner Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear Brake pipe slightly corroded both (3.6.B.2c)

Brake pipe slightly corroded both rear (3.6.B.2c)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Brake pipe slightly corroded both rear (3.6.B.2c)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Power steering component(s) has slight seepage from a component (2.3.3b)

front pads possibly below legal limit,

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Oil leak

Offside Headlamp aim too high and too far to the right. (1.8)

Stop lamp not working (1.2.1b)

nail in offside rear tyre

screw in nearside rear tyre

nail in offside rear tyre

screw in nearside rear tyre

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)