2006 Toyota Aygo

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Exhaust has a major leak of exhaust gases manifold blowing (6.1.2 (a))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding unable to check bearing (1.2.1 (f))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Suspension arm ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both rear bushes (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer sill corroded

sills,floors and chassis slightly corroded

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Position lamp not working both (4.2.1 (a) (ii))

Front Suspension arm ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both rear bushes (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer sill corroded

Offside Headlamp aim too low (4.1.2 (a))

sills,floors and chassis slightly corroded

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt both sides (2.4.G.2)

Rear Brake pipe slightly corroded both sides (3.6.B.2c)

front and rear pads and discs cant see wheel cover on

Nearside Rear Road wheel slightly damaged (4.2.A.1a)

Nearside Front Road wheel slightly damaged (4.2.A.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Road wheel slightly damaged (4.2.A.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Headlamp aim too low (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

tracking on front needs checking