2002 Mercedes-benz Vito

Fuel Pipe/s corroded ()

Brake hose has slight corrosion to ferrule all four (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened o/s n/s (1.1.14 (a) (ii))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened o/s n/s (1.1.14 (a) (ii))

Rear Tyre worn close to legal limit/worn on edge o/s n/s (5.2.3 (e))

all body around corroded wheel arches corroded bottom doors corroded holed

underneath corroded / all front rear suspension corroded bushes worn

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength several holes around front subframe (5.3.6 (a) (i))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner chassis where sub frame bolt sit (5.3.6 (a) (i))

Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front to rear sill (5.3.6 (a) (i))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front to rear sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mounting (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front to rear sill (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front to rear sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Parking brake efficiency below requirements o/s n/s (1.4.2 (a) (i))

Brake hose has slight corrosion to ferrule all four (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened o/s n/s (1.1.14 (a) (ii))

Fuel Pipe/s corroded ()

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened o/s n/s (1.1.14 (a) (ii))

Rear Tyre worn close to legal limit/worn on edge o/s n/s (5.2.3 (e))

all body around corroded wheel arches corroded bottom doors corroded holed

underneath corroded / all front rear suspension corroded bushes worn

Emissions not tested (8.2.2.2 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sills andsill backs (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength several areas sub frame mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength several areas sill and sill back (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sub frame mount and several areas (5.3.6 (a) (ii)) DANGEROUS

door bottoms holed

rear tyres wearing low on edges

rear cross member holed

rear tyres wearing on edges shocks deteriorating

van loaded when tested

van rusty through out

Emissions not tested (7.4.B.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front tyres on limit!!!!!

rear tyres wearing on inner edges

van very rusty through out

water in head light

brake readings low

rear cross member holed

rear tyres wearing on edges front tyres wearing low

underside very rusty

Nearside Front Lower ball joint slight play

both front antiroll bar d bushes worn

both front tyres worn on inner edges

general underbody corrosion

Body has slight corrosion (6.1.B.2)

Nearside centre outer sill corroded and holed but not within a prescribed area and not affectiong braking or steering

Vehicle structure has slight corrosion (6.1.A.1)

Brake load sensing valve seized (3.6.E.3)

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Body has slight corrosion (6.1.B.2)

Nearside centre outer sill corroded and holed but not within a prescribed area and not affectiong braking or steering

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

ALL TYRES SHOWING WEAR ON EDGES

Centre Exhaust has a major leak of exhaust gases (7.1.2)

ALL TYRES SHOWING WEAR ON EDGES

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nail in nearside rear tyre

slight play in both front anti-roll bar bushes