2008 Ford Ka

Offside Headlamp aim too low (4.1.2 (a))

All direction indicators adversely affected by the operation of another lamp DUE TO FAULTY SWITCH (4.4.3 (b))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength AT OUTER SILL (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength AT OUTER SILL (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Nearside Front buckled wheel

advise on corroded outer sills

Headlamp switch does not immediately illuminate all dipped beam headlamps dip/main beam switch sticking on main (4.1.3 (a))

Nearside Front Inner wheel bent/poor

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

front floor n/s,inner sills,rear chassis areas-corrosion

o/s/f tyre on limit/bald inner edge

rear boot floor area accident damage

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch behind trim (5.3.6 (a) (i))

Nearside Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced floor holed @ seat mount (7.1.1 (a) (i))

Offside Front Lower Coil spring fractured or broken (5.3.1 (b) (i))

Offside Headlamp aim too low very (4.1.2 (a))

Offside Headlamp levelling device inoperative (4.1.5 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch behind trim (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill behind axle,outer sill (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor holed @ seat mount (7.1.1 (a) (i))

Headlamp switch does not immediately illuminate all dipped beam headlamps dip/main beam switch sticking on main (4.1.3 (a))

Nearside Front Inner wheel bent/poor

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

front floor n/s,inner sills,rear chassis areas-corrosion

o/s/f tyre on limit/bald inner edge

rear boot floor area accident damage

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Outer Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

minor rear corrosion

Front Anti-roll bar linkage ball joint dust cover missing both (5.3.4 (b) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Outer Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

minor rear corrosion

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)