2013 Hyundai I10

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Offside Headlamp aim too low (4.1.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Position lamp not working both front (4.2.1 (a) (ii))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Outer Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Electrical wiring inadequately supported engine loom above gearbox. (1.9.2a)

Nearside Headlamp aim too low (1.8)

Nearside Stop lamp not working (1.2.1b)

Nearside Stop lamp not working (1.2.1b)

Offside Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)