1989 Volkswagen Lt

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch areas (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced front and rear (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Prop shaft flexible coupling slightly deteriorated (6.1.7 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Parking brake lever pivot worn to the extent that the brake may inadvertently release (1.1.6 (b) (ii))

Parking brake lever ratchet not holding correctly (1.1.6 (a))

Prop shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch areas (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced front and rear (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe inadequately clipped or supported to brake hose (1.1.11 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Prop shaft flexible coupling slightly deteriorated (6.1.7 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced Throw the chassy (6.1.1 (c) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Anti-roll bar missing Front Anti-roll bar rear clamp missing (5.3.3 (a) (ii)) DANGEROUS

Vehicle structure is corroded but structural rigidity is not significantly reduced Throw the chassy (6.1.1 (c) (i))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear offside rear back plate rusty/holed

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Parking brake lever pivot obviously worn (1.1.6 (b) (i))

Prop shaft bearing has slight play (6.1.7 (b) (i))

Rear rear spring bushes starting to perish

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

some side/rear body marker lights not working

Nearside Rear Inner Tyre(s) of different size tyres are fitted on twin wheels (5.2.3 (b))

Nearside Rear Stop lamp(s) emits other than a steady red light (4.3.3 (a) (ii))

Offside Rear Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Offside Rear Stop lamp(s) emits other than a steady red light (4.3.3 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Prop shaft bearing excessively worn (6.1.7 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake load sensing valve stiff (1.1.17 (c) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear offside rear back plate rusty/holed

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Parking brake lever pivot obviously worn (1.1.6 (b) (i))

Prop shaft bearing has slight play (6.1.7 (b) (i))

Rear rear spring bushes starting to perish

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

some side/rear body marker lights not working

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Nearside Rear Inner Nail in tyre + tyre low on air ()

Offside Front wheel arch / lower step rusty / holed

Offside Rear brake back plate rusty / holed

Offside dash / speedo insecure

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever pivot obviously worn (1.1.6 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

drivers seatbelt stork cover missing

propshaft centre bearing fitted wrong

some side / rear body marker lights not working

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Headlamp insecure (4.1.1 (c))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis section (6.1.1 (c) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Nearside Rear Inner Nail in tyre + tyre low on air ()

Offside Front wheel arch / lower step rusty / holed

Offside Rear brake back plate rusty / holed

Offside dash / speedo insecure

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever pivot obviously worn (1.1.6 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

drivers seatbelt stork cover missing

propshaft centre bearing fitted wrong

some side / rear body marker lights not working

Nearside Rear light lense damaged

Offside Front inner w/arch and lower step rusty/holed

Offside Rear brake backplate rusty / holed

Offside seatbelt stork cover missing

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Rear Other passenger door does not latch securely closed (6.2.3 (a))

Nearside Rear light lense damaged

Offside Front inner w/arch and lower step rusty/holed

Offside Rear brake backplate rusty / holed

Offside seatbelt stork cover missing

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced wing / arch areas (7.1.1 (a) (i))

Nearside Side repeater lens defective such that the emitted light is adversely affected (4.4.1 (b) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Prop shaft bearing housing insecure centre rubber worn (6.1.7 (f) (i))

Windscreen washer not working x 2 (3.5 (a))

Offside Rear Inner Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear light lense damaged

Offside Front inner w/arch and lower step rusty / holed

Offside Rear brake back-plate rusty / holed

Offside seat belt stork cover missing

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

some side body marker lights not working

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Play in propshaft centre bearing ()

front lower doorsteps corroded, not within prescribed area

slight corrosion throughout underside

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings jacking point (6.1.B.2)

Nearside Rear Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front position lamp(s) not working marker light (1.1.A.3b)

Parking brake mechanism/associated mounting prescribed area is excessively corroded (3.1.9)

Service brake: efficiency below requirements (3.7.B.7)

Steering component mounting prescribed area is excessively corroded (2.2.C.1h)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Play in propshaft centre bearing ()

chassis has surface corrosion

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

under side rusty

Nearside Front Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Offside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

under side rusty

Body has slight corrosion (6.1.B.2)

Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

Vehicle structure has slight corrosion (6.1.B.2)

Brake rod excessively corroded and seriously weakened (3.5.1e)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake mechanism/associated mounting prescribed area is excessively corroded (3.1.9) DANGEROUS

Nearside Shock absorber has a light misting of oil (2.7.3)

corrioson rear chassis