2004 Toyota MR2

Nearside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Position lamp not working all (4.2.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Bonnet primary retaining device ineffective (3.1 (c))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Offside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Exhaust noisy (7.1.4)

Nearside Rear Nail in tyre ()

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

idles slightly high

Front registration plate with character(s) which are not the correct width honeycomb (6.3.4a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Driver's seat insecure (6.2.A.1)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Rear registration plate displaying a honeycomb or similar effect background (6.3.3)

Exhaust noisy (7.1.4)

Nearside Rear Nail in tyre ()

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

idles slightly high

corrosion evident underside suspension conponents etc

Front registration plate with character(s) which are not the correct height (6.3.4a)

corrosion evident underside suspension conponents etc

Rear Parking brake lever has little reserve travel (3.1.6b)

Brakes imbalanced across an axle (3.7.B.5b)

Coil spring mounting loose (2.4.C.3a)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)