1989 Fiat Ducato

Brake lever has abnormal movement of levers indicating excessive wear or maladjustment (1.1.15 (f))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive 9.345 % (8.2.1.2 (b))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt both sides (6.1.7 (g) (ii))

Front Position lamp not working (4.2.1 (a) (ii))

Front Windscreen washer not working (3.5 (a))

Headlamp aim not tested (4.1.2 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Headlamp light intensity severely reduced dip main just a glow no effort of light (4.1.4 (a))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Exhaust fumes causing a danger to health of persons on board blow (6.1.2 (b) (ii)) DANGEROUS

Rear Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Front Vehicle structure is corroded but structural rigidity is not significantly reduced hard to get to to have good look wheels need to be removed (6.1.1 (c) (i))

Emissions not tested Engine overheating (8.2.1.2 (d))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Indicator tell-tale inoperative (4.9.1 (a) (i))

Front Lower Body has slight corrosion bumper (6.1.B.2)

Front Lower Body has slight corrosion offside & nearside cab door bottoms, (6.1.B.2)

Front Suspension spring mounting prescribed area is corroded but not considered excessive offside & nearside, wheel arch seem lip, over in front of the road wheels, in front of leg strut support (2.4.A.3)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive rear of cab door steep (5.2.6)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear Lower Leaf spring shackle bracket corroded but not seriously weakened all four spring mounting hangers (2.4.B.6d)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

the rear offside & nearside leaf springs are rusting

Brakes imbalanced across an axle (3.7.B.5b)

Centre Exhaust system not adequately supported (7.1.1)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Brake pipe inadequately clipped (3.6.B.1)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Corrosion on springs,suspension,chassis,crossmembers,etc.

Front scuttle corroded

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Tyre worn close to the legal limit (4.1.E.1)

welded repairs to sills,inner sills,floor areas

Nearside Headlamp aim too high (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Windscreen washer provides insufficient washer liquid (8.2.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

all suspension components are corroded

front inner wheel arches corroded

front scuttle to bulkhead corroded

front tyres are getting low on the outer edges of tread

horn sounds worn

unable to inspect wippers clearing the drivers view

underside corroded

wippers slow to operate

Brake load sensing valve linkage seized (3.6.E.3)

Exhaust system not adequately supported (7.1.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front Upper Brake pipe fouled by moving parts (3.6.B.2a)

Nearside Rear Brake pipe excessively damaged (3.6.B.2c)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake pipe seriously damaged (found during steering lock to lock check) (2.2.D.2b)

Offside Front Direction indicators not working (1.4.A.2c)

Offside Rear Brake pipe excessively damaged (3.6.B.2c)

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Battery insecure

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Leaf spring deteriorated but not seriously weakened (2.4.B.1a)

o/side suspension joint dust cover missing

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension joint offside lower dust cover split/missing

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Exhaust mounting missing (7.1.1b)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front Direction indicators not working (1.4.A.2c)

Offside Front Headlamp aim too high (1.8)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear Exhaust system not adequately supported (7.1.1)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension joint offside lower dust cover split/missing

Brake pedal creeps down under servo assistance and touches the floor (3.3.C.3)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside front brake binding (3.7.B.1)

Offside Front Direction indicator not working (1.4.A.2c)

Offside front brake binding (3.7.B.1)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front brake disc slightly pitted (3.5.1h)