1989 Volvo 240

Brake disc worn, pitted or scored, but not seriously weakened All (1.1.14 (a) (ii))

Brake hose slightly deteriorated All (1.1.12 (b) (ii))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Brake warning device malfunctioning or defective (1.1.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Windscreen wiper not working (3.4 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Registration plate lamp not working (1.1.C.1d)

Stop lamp not working (1.2.1b)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too low (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Axle has inadequate clearance with the bump stop (2.4.A.1a)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)