1989 Land Rover Defender

Nearside a piler rusty

Offside Front hub seal weeping

Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Brake disc contaminated (1.1.14 (b))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected chasis (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected chasis (5.3.6 (a) (ii)) DANGEROUS

Rear Vehicle structure is so weakened by corrosion within 30cm of a towbar mounting, the towbar is likely to become detached crossmember (6.1.6 (i) (ii)) DANGEROUS

Nearside a piler rusty

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front hub seal weeping

Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Front Steering linkage ball joint has excessive play drop arm ball joint (2.1.3 (b) (i))

Nearside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

nearside front swivel housing leaking

off/side/front wheel bearing slight play

Bonnet cannot be secured in the closed position (8.4.1)

Central Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Headlamp does not operate immediately when selected on dipped beam (1.7.4a)

Main beam 'tell-tale' not working (1.7.4c)

Nearside Front Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Brake pipe kinked (3.6.B.2b)

Offside Front Inner Brake pipe excessively corroded (3.6.B.2c)

Offside Front Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Shock absorber detached (2.7.2b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Power steering pump leaking from a failed component (2.3.3b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Propshaft universal joint worn ()

nearside front swivel housing leaking

Ball joint has slight play steering joint where chalked (2.2.B.1f)

Bonnet retaining device slightly deteriorated release cable seized (8.4.2)

Front Brake pad(s) wearing thin both (3.5.1g)

Offside Front wheel bearing has slight play (2.5.A.3c)

Nearside Front wheel bearing rough when rotated and slight play (2.5.A.2)

Ball joint has slight play steering joint where chalked (2.2.B.1f)

Bonnet retaining device slightly deteriorated release cable seized (8.4.2)

Front Brake pad(s) wearing thin both (3.5.1g)

Offside Front wheel bearing has slight play (2.5.A.3c)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings battery tray (6.1.B.2)

Offside Rear Shock absorber detached (2.7.2b)

Nearside Front Body has slight corrosion floor (6.1.B.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

slight play in steering drop arm

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Drag link end ball joint has excessive play (2.2.B.1f)

Windscreen washer provides insufficient washer liquid (8.2.3)

battery box corroding

n/s/f floor corroding

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Rear wheel bearing rough when rotated (2.6.1)

Steering pivot point has excessive play (2.2.B.1g)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

battery box corroding

n/s/f floor corroding

Nearside Rear Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

slight play in steering damper

steering drop arm dust cover slightly deteriorated

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Non obligatory mirror damaged

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Oil leak

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Brake master cylinder fluid level below minimum level (3.6.G.1e)

Nearside Front Seat belt has a cut which has significantly weakened the webbing (5.2.2a)

Offside Front Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Nearside Front Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Offside Front Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)