2003 Mazda MX-5

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

undersealed

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill back plate (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering chassis (6.1.1 (c) (ii)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear offside rear inner wheel arch slight corrosion, not significantly weakened

underbody corrosion

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear offside rear inner wheel arch slight corrosion, not significantly weakened

underbody corrosion

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively damaged significantly reducing structural strength inner sealing (5.3.6 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Headlamp lens slightly defective both front (4.1.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Lower wings corroded

Sub-frame corroded but not seriously weakened and rear arms (5.3.3 (b) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill/floor (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill/floor (5.3.6 (a) (i))

Front Lower wings corroded

Sub-frame corroded but not seriously weakened and rear arms (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Brake pipe leaking on an air braking system across rear axle (1.1.11 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Service brake excessively binding (1.2.1 (f))

Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

both rear inner sills corroded

Offside Rear coil spring modified but not seriously weakened (2.4.A.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front front brake binding (3.7.B.1)

Offside Rear coil spring modified but not seriously weakened (2.4.A.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front position lamp(s) not working flickering (1.1.A.3b)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering pipe(s) or hose(s) leaking pipe corroded and leaking (2.3.3b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear tyre worn inner edge

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Subframe mounting prescribed area is severely distorted (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Road wheel slightly damaged (4.2.A.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)