1988 Nissan Sunny

Suspension component mounting prescribed area is corroded but not considered excessive all over (5.3.6 (a) (i))

door corroded hole n/s/r

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords both fronts (5.2.3 (d) (i))

Suspension component mounting prescribed area is corroded but not considered excessive all over (5.3.6 (a) (i))

door corroded hole n/s/r

corrosion to underside

tyres cracking

Body has a sharp edge caused by corrosion (6.1.C.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Suspension component mounting prescribed area is excessively corroded sill caps (2.4.A.3)

corrosion to underside

tyres cracking

all four tyres slightly perished on the side walls

coil spring corroded all 4 (2.4.C.1b)

corrosion on inner sills, floors, chassis

Offside Front Front suspension has excessive play in a lower wishbone bearing (2.5.B.1a)

Offside Steering rack gaiter split (2.2.D.2d)

coil spring corroded all 4 (2.4.C.1b)

corrosion on inner sills, floors, chassis

Slight surface corrision to underside

Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate insecure (6.3.1b)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

coil spring corroded (2.4.C.1b)

corrosion to underside

tyres cracking

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

coil spring corroded (2.4.C.1b)

corrosion to underside

tyres cracking

Front Body has a sharp edge caused by corrosion (6.1.C.1)

Front registration plate insecure (6.3.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

corrision to underside

front plate cracked

Offside Rear Braking system leaking (3.6.A.1)

Service brake: efficiency below requirements (3.7.B.7)

corrision to underside

front plate cracked

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Side repeater not working (1.4.A.2c)

Power steering component(s) leaking (2.3.3b)

vehicle has slight underside corrision

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Power steering component(s) leaking (2.3.3b)

vehicle has slight underside corrision

slight pas fluid mist on rack

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Service brake: efficiency below requirements (3.7.B.7)

slight pas fluid mist on rack

Power steering pump has slight seepage from a component (2.3.3b)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Power steering pump has slight seepage from a component (2.3.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)