1989 Fiat Panda

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Brake performance not tested vehicle considered unsafe (1.2.1 (g))

Hazard warning lamps inoperative wiyh ignition off (4.4.1 (e))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer inner sill and wheel well (6.2.2 (d) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill repaired not welded around entire patch (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chasis leg under rear wheel arch (6.2.2 (d) (i))

Stop lamp(s) adversely affected by the operation of another lamp dont work with hazards (4.3.3 (b))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

both front flexi securing brackets corroded off

Nearside Front Ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Fuel tank leaking (7.2.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Stop lamp not working (1.2.1b)

Nearside Front Ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Brake performance not tested (3.7.A.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front registration plate obscured (6.3.1d)

Horn not working (1.6.2a)

Nearside Inner Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp not working on main beam (1.7.5a)

Offside Inner Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)