1988 Austin Mini Designer

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Headlamp aim beam image obviously incorrect Headlamp mounted upside down (1.8.A.1b)

Offside rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Upper Driver's door hinge insecure (6.2.B.2)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Nearside front suspension siezed

osf tyre cut

Body damage bonnet

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive Floor pan (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive Floor pan (2.4.A.3)

Oil leak

Rear Exhaust hanger nut is missing but exhaust is still suported

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt lower (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Body damage bonnet

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive Floor pan (2.4.A.3)

Nearside Windscreen wiper not tested

Offside Front Subframe mounting prescribed area is corroded but not considered excessive Floor pan (2.4.A.3)

Offside Windscreen wiper not tested

Oil leak

Rear Exhaust hanger nut is missing but exhaust is still suported

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Stop lamp remains on when the brakes are released (1.2.1e)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear wheel bearing rough when rotated (2.6.1)

Offside Stop lamp remains on when the brakes are released (1.2.1e)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Body damage bonnet

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside front inner wheel arch has corosion

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Reae exhaust hanger nut missing but exhaust is still suported

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Bonnet has damage

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Fuel hose to pipe clip is missing

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Bonnet has damage

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Fuel hose to pipe clip is missing

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Main beam 'tell-tale' not working (1.7.4c)

Offside Front position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Parking brake: efficiency below requirements (3.7.C.1b)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

o/s headlamp aim not tested

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear wheel bearing has slight play (2.6.2)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust engine idle speed too high (7.3.A.2a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Clutch pedal rubber missing

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear wheel bearing has slight play (2.6.2)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Headlamp main beam warning lamp not working

Nearside Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s lower engine mounting fixing loose

Front registration plate font not substantially similar to the prescribed font (6.3.4d)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Headlamp aim too high (1.8)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Headlamp aim too high (1.8)

Offside Rear Lower Shock absorber has an excessively worn bush (2.7.4)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Rear registration plate font not substantially similar to the prescribed font (6.3.4d)

Headlamp main beam warning lamp not working

Nearside Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

brake test carried out by decelerometer -- no kerb wieght

n/s lower engine mounting fixing loose

Eng steady bar bush worn.

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

All position lamps not working (1.1.A.3b)

Brake pedal anti-slip provision missing (3.3.A.1b)

Brake pipe excessively corroded (3.6.B.2c)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Offside Front Direction indicators not working (1.4.A.2c)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Steering rack gaiter split (2.2.D.2d)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Wheel nut(s) loose (4.2.A.1e)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Drivers seat back broken.

Engine steady bar bush worn.

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Horn not working (1.6.2a)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Offside Front Horn not working (1.6.2a)

Offside Rear Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)