1988 Austin Mini Designer

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Floor insecure (6.2.4 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner and outer (6.1.1 (c) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Upper Shock absorbers insecurely attached mounting corroded (5.3.2 (a) (i))

Offside Front Upper Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

Offside door corroded

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Vehicle structure strengthening plate or fastening so insecure that structural rigidity is seriously reduced (6.1.1 (b) (ii)) DANGEROUS

Offside door corroded

Body has slight corrosion battery box (6.1.B.2)

Exhaust noisy (7.1.4)

Fuel pipe corroded but not leaking

Oil leak ()

Body has slight corrosion battery box (6.1.B.2)

Exhaust noisy (7.1.4)

Fuel pipe corroded but not leaking

Oil leak ()

Registration plate lamp not working (1.1.C.1d)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded sill & heal board (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear wheel bearing rough when rotated (2.6.1)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Exhaust noisy (7.1.4)

battery box corroded

Fuel pipe/s corroded

Nearside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Sub-frame attachment slightly corroded (2.4.G.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Sub-frame attachment slightly corroded (2.4.G.1)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

rear wheel bearings slightly noisey

Front Exhaust has a major leak of exhaust gases (7.1.2)

Offside Headlamp not working on main beam (1.7.5a)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Fuel pipe/s corroded

Nearside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Sub-frame attachment slightly corroded (2.4.G.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Sub-frame attachment slightly corroded (2.4.G.1)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

rear wheel bearings slightly noisey

Brakes imbalanced across an axle (3.7.B.5b)

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Front Brake pipe inadequately supported (3.6.B.1)

Front engine mounting deteriorated resulting in excessive movement (6.1.D.1a)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Indicator switch insecure (1.4.A.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Tie bar/rod slightly distorted (2.4.G.1)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod slightly distorted (2.4.G.1)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Steering system has slight free play detected at steering wheel (2.2.A.1b)

all floors, outer sills and rear boot floors are all rust corroded in various places

both front tyres are wearing on inner / outer treads

o/sf shock absorber is weak

wiper stalk is insecure

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Hazard warning lamps inoperative (1.4.B.1b)

Indicator switch insecure (1.4.A.1)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Fuel pipe insecure (7.2.1) DANGEROUS

Engine stabilizer bar bushes badly worn

Fuel float chamber overflow pipe missing

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside and offside engine mountings worn

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Oil leak

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate deteriorated (6.3.1d)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Rear Upper Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust system not adequately supported (7.1.1)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Horn not working (1.6.2a)

Offside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Registration plate lamp not working (1.1.5c)

Parking brake: efficiency below requirements (3.7.B.7)