1989 Mercedes-benz 250

Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Inner Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust system not adequately supported (7.1.1)

Battery insecure

Fuel pipe/s corroded

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

n/s/f tyre scrubbing on edges

small tear in wiper

Fuel pipe leaking (7.2.3)

Headlamp aim too high (1.8)

n/s/f tyre scrubbing on edges

small tear in wiper

Brake hose ferrule excessively corroded (3.6.B.4e)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)

Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

brake disc excessively pitted (3.5.1h)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front coil spring incomplete (2.4.C.1a)

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Offside Front coil spring incomplete (2.4.C.1a)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)