1989 Land Rover Defender

Nearside Front Seat belt slightly damaged (7.1.2 (b) (i))

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Steering box has seepage (2.1.1 (e) (i))

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Horn not working (7.7 (a) (ii))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Hazard warning tell-tale inoperative (4.9.1 (a) (i))

No brakes tested because of front hub bearing faulty

Offside Front Swivel ball has slight oil leak

Nearside Front Seat belt slightly damaged (7.1.2 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Seat belt slightly damaged (7.1.2 (b) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Seat belt missing all rear (7.1.2 (a))

Windscreen washer not working (3.5 (a))

oil leak from sump area.

power steering box weaping oil.

rear diff prop shaft seal leaking oil.

transfer box leaking oil.

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

front brake pads rattle in caliper

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

front brake pads rattle in caliper

Brake pedal anti-slip provision missing (3.3.A.1b)

Centre Rear Statutory seat belt missing (5.1.1)

Hazard warning lamps inoperative all bulbs (1.4.B.1b)

Headlamp adversely affected by the operation of another lamp offside front dipped beam comes on when main beam is on and visa versa (1.7.5c)

Horn sounds harsh or grating (1.6.2e)

Nearside Headlamp aim too low (1.8)

Nearside Rear Statutory seat belt missing (5.1.1)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Nearside Track rod end ball pin shank loose (2.2.B.1c)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Statutory seat belt missing (5.1.1)

Offside Rear position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Brake fluid level on min

Exhaust blow and manifold

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Slight play in nearside front top swivel

play in front prop shaft front uj and rear uj

Offside Rear wheel bearing has excessive play (2.6.2)

Rear fog lamp not working (1.3.2b)

Registration plate lamp insecure (1.1.C.1c)

Steering column universal joint has excessive play (2.1.5)

coil spring corroded (2.4.C.1b)

steering column uj lower slight play

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Headlamp aim too low (1.8)

Nearside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Fuel pipe leaking (7.2.3)

Offside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear fog lamp not working (1.3.2b)

Offside Stop lamp not working (1.2.1b)

Shock absorber has an excessively worn bush (2.7.4)

Steering column universal joint has slight play (2.1.5)

coil spring corroded (2.4.C.1b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Registration plate lamp not working (1.1.5c)

Steering component mounting prescribed area is excessively corroded (2.2.C.1h)

Windscreen washer provides insufficient washer liquid (8.2.3)

no seat belts have been fitted to the rear of the vehicle when built.there is no requirement in this type of vehicle and was previously failed in error.

Rear Statutory seat belt missing (5.1.1)

Shock absorber has a slightly worn bush (2.7.4)