1989 Austin Mini Mayfair

heavily undersealed

Brake fluid warning lamp inoperative (3.6.G.2)

Brake has no servo assistance (3.3.B.2)

Centre Stop lamp not working (1.2.1b)

Electrical wiring insecure (1.9.2a)

Front Electrical wiring damaged and bare wires exposed (1.9.2c)

Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Lower Ball joint dust cover missing (2.2.C.1c)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too high (1.8)

Offside Rear Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Steering rack gaiter split (2.2.D.2d)

Offside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Rear fog lamp switch missing (1.3.1a)

Rear reflector missing (1.5.1a)

Speedometer cannot be illuminated. (6.7.3)

Bonnet latch faulty

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Coolant leak

Lower Ball joint has slight play (2.2.B.1f)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Oil leak

Speedo cable fouls drive shaft

Upper Ball joint has slight play (2.2.B.1f)

front brake juddering slightly (3.7.A.2b)

Body has a sharp edge caused by corrosion (6.1.C.1)

Centre Front Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust engine idle speed too high (7.3.A.2a)

Front registration plate missing (6.3.1a)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Horn not loud enough to be heard by another road user (1.6.2b)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Lower Ball joint has excessive play (2.2.B.1f)

Nearside Front Statutory seat belt missing (5.1.1)

Nearside Rear Statutory seat belt missing (5.1.1)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Lower Ball joint has excessive play (2.2.B.1f)

Offside Front Upper Ball joint has excessive play (2.2.B.1f)

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Rear Statutory seat belt missing (5.1.1)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear registration plate deteriorated (6.3.1d)

Registration plate lamp not working (1.1.5c)

Windscreen washer provides insufficient washer liquid (8.2.3)

offside rear tyre flat

poor gereneral body corrosion and condition

Nearside Front Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Front Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front registration plate letter/figure incomplete (6.3.1c)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Exhaust system not adequately supported (7.1.1)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Front drive shaft coupling flexible rubber or fabric coupling unit breaking up (2.5.C.1d)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Tyre fouling a part of the vehicle (4.1.D.2)

Offside Rear Rear fog lamp insecure (1.3.2a)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)