2004 Fiat Ducato

Nearside Front Inner Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Inner Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Horn sound not in accordance with requirements (7.7 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Headlamp aim too far to the right (4.1.2 (a))

rusty chassis

rusty suspension

stone chip in zone A

Brake master cylinder/servo mounting prescribed area is excessively corroded inside engine bay below brake master cylinder (1.1.21 (e) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inside wheel arch above wheel (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inside wheel arch near flexi brake hose mounting area (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outrigger (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill and outrigger (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inside wheel arch above wheel and in front of wheel (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength complete rear valance (5.3.6 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch near flexi brake hose (5.3.6 (a) (i))

chassis plate vin number not the same as frame number

Body has slight corrosion Both sides front near jacking points (6.1.B.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear silencer outer skin rusting

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Body has slight corrosion around jacking point and suspension arm rear mount (6.1.B.2)

Offside Front Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear silencer outer skin rusty

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear silencer outer skin corroded.

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

VIN plate does not match VIN number on chassis

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Horn not working (1.6.2a)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

VIN plate does not match VIN number on chassis

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)