2004 Rover 45

Offside Rear Brake pipe corroded, covered in grease or other material Slight Corrosion (1.1.11 (c))

Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Jacking Point / Floor Pan (6.1.1 (c) (i))

Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced Jacking Point / Floor pan (6.1.1 (c) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Horn not working (7.7 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Shock absorbers insecurely attached Nut missing from connecting fork (5.3.2 (a) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Outer Floor excessively deteriorated (6.2.4 (a) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Outer Tyre has ply or cords exposed Tread separation from casing (5.2.3 (d) (ii)) DANGEROUS

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill in wheel arch (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

both fron tyres wearing close to the legal limit

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Floor near roll bar mount (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Horn not working properly (7.7 (a) (i))

Offside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt OUTER CV GAITOR SLIGHT LEAK (2.5.C.1a)

Front Brakes rq attention slight bind on both brakes

Nearside Front Abs ring on drive shaft corroded

Nearside Rear Fuel tank filler neck corroded

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Brake pipe slightly corroded To hose in clip (3.6.B.2c)

Front Brakes rq attention slight bind on both brakes

Front Windscreen wiper does not clear the windscreen effectively Blades replaced (8.2.2)

Nearside Front Abs ring on drive shaft corroded

Nearside Rear Fuel tank filler neck corroded

Offside Headlamp aim too high Adjusted (1.8)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Brake pipe slightly corroded To hose in clip (3.6.B.2c)

Offside Rear position lamp(s) not working Bulb replaced (1.1.A.3b)

Rear Cracks in both tyres wall to tread area

CRACKS IN TREAD AREA N/S/FRONT TYRE

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Headlamp aim too high and too far to the right. (1.8)

Offside Headlamp aim too high (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Fuel tank leaking (7.2.3) DANGEROUS