1983 Ford Capri

All welding on car to poor standard and covered by underseal

Front brake discs very rusty

floors,sills and wheel arches very rusty and weak, holes in places but not structural to vehicle components

Bootlid cannot be secured in the closed position (6.4.1)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Direction indicators obviously incorrectly positioned (1.4.A.2b)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake hose twisted (3.6.B.4c)

Offside Rear Brake pipe inadequately clipped (3.6.B.1)

Offside Rear Exhaust system not adequately supported (7.1.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Stop lamp not working (1.2.1b)

All welding on car to poor standard and covered by underseal

Front brake discs very rusty

floors,sills and wheel arches very rusty and weak, holes in places but not structural to vehicle components

Body insecure and dangerous to other road users (6.1.B.1b)

Front passenger door cannot be opened from inside the vehicle (6.2.B.1b)

Fuel system component leaking (7.2.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Parking brake: efficiency below requirements (3.7.B.7)

Battery insecure

Offside Exhaust has a minor leak of exhaust gases (7.1.2)

both front brake discs corroded but not seriously weakened

both front bumper edges missing

large areas of the chassis are heavily undersealed and this makes it impossible to see properly.

near side inner and outer sill area slightly corroded and very heavily iundersealed

near side rear wheel arch area welded and heavily undersealed, I dont know what is underneath the welded area

off side front floor area welded from inside, unable to ascertain if welded completely

off side front inner wheel arch area welded and geavily undersealed, I dont know what is underneath the welded area

off side front wheel arch area has been welded before the MOT test, I dont know what is underneath it and whether it weas corroded

xorrosion on near side front floor but not within 30cm of structural points

Body insecure and dangerous to other road users (6.1.B.1b)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Steering rack gaiter split (2.2.D.2d)

Nearside rear brake binding (3.7.B.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Both front discs are quite corroded but not weakened

Front bumper is loose and has sharp edges at both ends but are not caused by damage or corrosion.

Many areas of chassis, under bonnet, front wheel arch areas are corroded and have been welded before and are covered in underseal.

Near side front upper wheel arch are is corroded but has been welded under bonnet.

Slight play in off side steering tie rod.

front floors corroded/rear chassis corroded/general corrosion/rear number plate honeycomb background/front inner arches corroded

Body insecure and dangerous to other road users (6.1.B.1b)

Brake pedal spongy (3.3.B.1b)

Direction indicator not working (1.4.A.2c)

Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear passenger seat cannot be secured in the upright position. (6.2.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear wheel cylinder leaking (3.6.A.1)

Offside Steering rack gaiter split (2.2.D.2d)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

front brake application uneven (3.7.B.2)

front floors holed and corroded/nsr chassis sp[lit and spring mount corroded/offside front inner wheel arch holed and corroded

front strut top mounts corroded/general corrosion/brake fluid low/rear number plate has honeycomb background

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

battery insecure

both front footwells holed and corroded

both front inner wings very corroded

both front wings holed and corroded

extensive patch repairs have been carried out to vehicle structure

offside baulkhead/transmission tunnel holed and corroded

rear seats and seat belts removed at time of test

vehicle structure very corroded and thin in places

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear fog lamp tell tale not working (1.3.1b)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

battery insecure

both front footwells holed and corroded

both front inner wings very corroded

both front wings holed and corroded

extensive patch repairs have been carried out to vehicle structure

offside baulkhead/transmission tunnel holed and corroded

rear seats and seat belts removed at time of test

vehicle structure very corroded and thin in places

Exhaust noisy (7.1.4)

Oil leak

front inner wings thin in places

nearside rear chassis rail slightly corroded

offside front floor holed but not within a perscribed area

Front registration plate missing (6.3.1a)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Hazard warning tell tale not working correctly (1.4.B.1e)

Horn not working (1.6.2a)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Nearside Rear reflector not red in colour (1.5.1d)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Wheel nut(s) missing (4.2.A.1e)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Outer Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear reflector not red in colour (1.5.1d)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear fog lamp switch insecure (1.3.1a)

Rear fog lamp tell tale not working (1.3.1b)

Exhaust noisy (7.1.4)

Oil leak

nearside rear chassis rail slightly corroded

offside front floor holed but not within a perscribed area

Fuel pipe leaking (7.2.3)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Inner Front Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Registration plate lamp not working (1.1.5c)

Nearside brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Power steering ram(s) leaking from a failed component (2.3.3b)

Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Inner Front Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Registration plate lamp not working (1.1.5c)

Offside brake disc in such a condition that it is seriously weakened (3.5.1i)

Rear Rear fog lamp not working (1.3.2b)

Steering rack excessively corroded and unserviceable (2.2.C.1d)

front brake application uneven (3.7.B.2)

rear brake application uneven (3.7.B.2)

oil leaks

radiator poor condition

front brake readings fluxuate slightly

nearside and offside front a pillars corroded

rear suspension leaf spring bushes weak

vehicle structure by repair patches thin in places

Centre Exhaust mounting missing (7.1.1b)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Brake clevis joint locking device missing (3.5.1l)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Offside Front Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image too far to the right (1.6.B4)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake clevis joint locking device missing (3.5.1l)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Steering rack gaiter split (2.2.D.2d)

Rear Brake pipe fouled by moving parts (3.6.B.2a)

Rear Brake pipe inadequately clipped (3.6.B.1)

front brake readings fluxuate slightly

nearside front and offside front a pillars corroded

offside rear flexi brake pipe insecure

rear suspension leaf spring bushes weak