2012 BMW M3

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear Brake pipe corroded, covered in grease or other material o/s and n/s bubbling under plastic coating (o/s to n/s) (1.1.11 (c))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Suspension component pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Macpherson strut damaged but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre slightly damaged/cracking or perishing Perishing / cracks (5.2.3 (d) (ii))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Pad wear sensor wire damaged

Offside Rear Brake pad wear cable damaged

Headlamp aim too low Both (4.1.2 (a))

Offside Rear Brake pad wear cable damaged

plastic covers fitted underneath

engine cover fitted obscuring the view of some components

under trays fitted obscuring the view of some components

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure inner side wall (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

engine cover fitted obscuring the view of some components

under trays fitted obscuring the view of some components