2008 Mazda 6

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 225/40-18 (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Inner Suspension component mounting prescribed area is inadequately repaired sill (5.3.6 (a) (i))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 225/40-18 (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Seat belt buckle missing (7.1.2 (d))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear susspention corroded

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear susspention corroded

Brake lever has insufficient reserve travel (1.1.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Service brake excessively binding both x 2 (1.2.1 (f))

Front Suspension arm ball joint excessively worn both x 2 (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Rear Vehicle structure has slight damage (6.1.A.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

considerable damage to windscreen out side of zone'a' 'does not meet fail criteria'

rear brake pads wearing thin and discs in poor condition