2006 Skoda Superb

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Both rear side light output slightly reduced.

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Both rear side light output slightly reduced.

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Engine management lamp illuminated.

Offside Front Service brake binding but not excessively (1.2.1 (f))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Cuts in sidewall of drivers rear tyre.

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Cuts in sidewall of drivers rear tyre.

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Tyre(s) incorrect because a lightweight or space saving wheel is fitted (4.1.A.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS