2007 Alfa Romeo GT

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Driver's door cannot be opened from outside the vehicle door handle broken (6.2.3 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Exhaust has a minor leak of exhaust gases rear box joint (6.1.2 (a))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords torn in places on outer side wall (5.2.3 (d) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords torn in places on outer side wall (5.2.3 (d) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Brake lever has insufficient reserve travel Hand brake (1.1.2 (a))

Emissions not tested (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak Exaust back box has a gas leak (8.2.1.1 (b))

Front Windscreen washer not working (3.5 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre has ply or cords exposed also on 1.6mm (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Both front suspension strut bushes are worn

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords On side wall (5.2.3 (d) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Rear Suspension top mount has slight play

Rear Exhaust has a minor leak of exhaust gases joint (7.1.2)

Under trays fitted obscuring some components

Nearside Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement inner bushs (2.4.G.2)

Offside Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement inner bushs (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Exhaust has a minor leak of exhaust gases joint (7.1.2)

Under trays fitted obscuring some components

Nearside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Lower Ball joint has slight play (2.2.B.1f)

Offside Rear coil spring corroded (2.4.C.1b)

Rear Exhaust has a minor leak of exhaust gases on joint (7.1.2)

Nearside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too high (1.8)

Nearside Rear coil spring corroded (2.4.C.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Lower Ball joint has slight play (2.2.B.1f)

Offside Rear coil spring corroded (2.4.C.1b)

Rear Exhaust has a minor leak of exhaust gases on joint (7.1.2)

Nearside Rear coil spring corroded and offside (2.4.C.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

nsr seat lock/latch mechanism has intermittant fault ok at time of test

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

very slight lift at both lower ball joints

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)