2005 Alfa Romeo GT

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases flexi pipe (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i))

Exhaust has a minor leak of exhaust gases flexi pipe (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Front Lower Subframe mounting prescribed area is corroded but not considered excessive body sill (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front N/S/F Seal area corrosive...not in prescribed area

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

reverse light not working

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

reverse light not working

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear tyre worn on inside edge

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too high and too far to the right. (1.8)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Rear tyre worn on inside edge

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

air bag warning light on

Centre Exhaust system not adequately supported (7.1.1)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp aim too high (1.8)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Oil leak

front number plate slightly damaged

nearside rear brake binding slightly

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.5c)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Offside Registration plate lamp not working (1.1.5c)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

both front tyres wearing on inner edges

slight crack front number plate

Nearside Rear Brake lining(s) wearing thin (3.5.1g)

Offside Rear Brake lining(s) wearing thin (3.5.1g)

Nearside Inner Rear Lower Tyre worn close to the legal limit (4.1.E.1)

Offside Inner Rear Lower Tyre worn close to the legal limit (4.1.E.1)