2005 Mazda 6

Offside Front constant velocity joint is insecure (2.5.C.1b)

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Front Headlamp insecure (1.7.3)

Nearside Front Lower Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front constant velocity joint is insecure (2.5.C.1b)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Parking brake: efficiency below requirements (3.7.B.7)

Front bumper insecure

Gearbox mounting defective

emissions not done due to engine stalling

gearbox mounting slightly split

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Headlamp aim too high (1.8)

Suspension joint nearside lower dust cover split/missing

Nearside Headlamp aim too low (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Outer Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

engine management light on

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)