2006 Toyota Aygo

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension arm ball joint likely to become detached securing device missing (5.3.4 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front abs loom incorrectly located

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

underside of vehicle in general is HEAVILY coroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

general under body corrosion

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

general under body corrosion

Front Position lamp incorrect colour (4.2.3 (a) (i))

Front Tyre worn close to legal limit/worn on edge both sides edges wearing (5.2.3 (e))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Coil spring corroded (5.3.1 (b) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Coil spring corroded (5.3.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced sub frame (6.1.1 (c) (i))

Front registration plate deteriorated (6.3.1d)

Nearside Front Inner brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

screw in n/s/r tyre

Hazard warning switch faulty (1.4.B.1d)