2008 Yamaha YQ50

Dip/main beam switch working wrong way around

Front brake has no feel not much movement in lever

Front mudguard missing

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Engine mounting/bracket bracket damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i))

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Headlamp aim not tested kitchen down light bulb fitted (4.1.2 (b))

Headlamp insecure kitchen down light bulbs fitted (4.1.1 (c))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Horn not working (7.7 (a))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

leg shield loose bolts missing

Front brake has no feel not much movement in lever

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

All direction indicators not working (4.4.1 (a) (ii))

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Registration plate does not conform to the specified requirements (0.1 (d))

Registration plate deteriorated (6.3.1d)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Registration plate deteriorated (6.3.1d)

Nearside Rear Lower Brake pad(s) close to minimum limit (3.2.A1f(i))

Offside Front Lower Brake pad(s) close to minimum limit (3.2.A1f(i))