2009 Hyundai I10

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Front Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Offside Front Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened and both springs (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Front Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Offside Front Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened and both springs (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

clutch hard to engage

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp has a product on the lens so that the light output is severely reduced and nearside. (4.1.4 (b))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

clutch difficult to engage and disengage,

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Service brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too high (1.8)

Play in steering rack inner joint(s)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Play in steering rack inner joint(s)

Rear Brake pad(s) wearing thin (3.5.1g)