2003 Daihatsu Hijet

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Upper Steering column top bearing slightly worn (2.2.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Upper Steering column top bearing slightly worn (2.2.2 (b))

Brake hose has slight corrosion to ferrule all unchanged (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material all unchanged (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Front Registration plate inscription illegible (0.1 (b))

Offside Rear Brakes imbalanced across an axle low effort (1.2.1 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sll (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

corrosion to front and rear lower quarters

exhaust poor condition

offside rear tyre has a cut on inner side wall

Child seat fitted not allowing full inspection of adult belt

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Front Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

front number plate is cracked

o/s front lower suspension arm mounting bush is worn

o/s head light lens is damaged

rear leaf springs mounting bushes are perished and worn

rear number plate has started to delaminate

Brake load sensing valve linkage seized (3.6.E.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Child seat fitted not allowing full inspection of adult belt

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Front Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

front number plate is cracked

o/s front lower suspension arm mounting bush is worn

o/s head light lens is damaged

rear leaf springs mounting bushes are perished and worn

rear number plate has started to delaminate

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Headlamp aim too low (1.8)