2004 Honda Civic

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Sub-frame corroded but not seriously weakened front and rear inc suspension components (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Exhaust noisy (8.1.1 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

COVER SILLS FITTED

Rear Inner Subframe mounting prescribed area is corroded but not considered excessive O/S AND N/S (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Front front brake binding O/S AND N/S (3.7.B.1)

Headlamp aim too low O/S AND N/S (1.8)

Offside Front Front position lamp(s) not working (1.1.A.3b)

COVER SILLS FITTED

Front Brake pad(s) wearing thin (3.5.1g)

Rear Inner Subframe mounting prescribed area is corroded but not considered excessive O/S AND N/S (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside front brake grabbing slightly (3.7.A.2b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres distorted slightly

handbrake travel high

strong advise both front tyres bald on inner edges & close to cords