2005 Peugeot 206

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

under seal applied

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Sub-frame corroded but not seriously weakened Surrounding suspension components also slightly corroded (5.3.3 (b) (i))

Front Windscreen damaged but not adversely affecting driver's view Stone-chip (3.2 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Axle corroded, but not seriously weakened, Surrounding suspension components also slightly corroded

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Windscreen wiper blade defective Both smearing (3.4 (b) (i))

Front Brake disc significantly and obviously worn front discs inner faces (1.1.14 (a) (i))

Offside Brake pipe excessively corroded offside front to rear to offside rear flex (1.1.11 (c))

Offside Front Brake pipe excessively corroded to off side front flex hose (1.1.11 (c))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

front brake discs slightly worn

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Silencer outer skin corroded and split

Front Brake hose ferrule excessively corroded (3.6.B.4e)

Front front brake application uneven (3.7.B.2)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Silencer outer skin corroded and split

near side front abs sensor wiring bracket missing

off side front tyre worn on outer edge

advise chip in A zone of windscreen less than 10m/m

advise left front tyre wearing on outer edge

Coolant leak

Offside Front Lower Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)