2006 Toyota Aygo

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Front Inner Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear brake pipe and furrel corroding

Nearside Rear coil spring corroded at bottom

Nearside Rear tyre has sidewall damage

Offside Rear brake pipe and furrel corroding

underside corrosion various areas

exhaust mounts corroding

Nearside Headlamp aim too high (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

exhaust mounts corroding

Front Brake pad(s) wearing thin (3.5.1g)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Nearside Front position lamp(s) not working (1.1.A.3b)