2001 Toyota Yaris

Central Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both rear tyres (5.2.3 (d) (ii))

Front Tyre worn close to legal limit/worn on edge both side (5.2.3 (e))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Tyre worn close to legal limit/worn on edge both side (5.2.3 (e))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Position lamp not working (4.2.1 (a) (ii))

Body has slight corrosion (6.1.B.2)

Front Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Body has slight corrosion (6.1.B.2)

Front Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

n/side front tyre outer side wall has small buldge.