2002 Fiat Ducato

SLIGHT CORROSION TO THE UNDERSIDE OF THE VEHICLE

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Exhaust mounting defective (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material Both Sides (1.1.11 (c))

Front Power steering pipe/hose slightly corroded

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material Both Sides (1.1.11 (c))

Wax oil has sprayed to the underside of the vehicle

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Exhaust mounting defective (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Lower Suspension arm ball joint has slight play BBJ (5.3.4 (a) (i))

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

RECENT REPAIRS COVERED IN UNDER SEAL

Rear AIR SUSPENSION NOT TESTED

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security BOTH SIDES (6.2.2 (d) (i))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Horn not working (7.7 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch adjacent to suspension top mounting (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point area adjacent to subframe mountings. (5.3.6 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch adjacent to suspension top mounting (5.3.6 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing adjacent to subframe mounting (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point adjacent to subframe mounting (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Exhaust mounting defective has temp repair (6.1.2 (a))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Headlamp aim too low (1.8)

2 exhaust mountings broken, but exhaust secure at time of test.

Slight corrosion to OSF inner wing, ok at time of test.

2 exhaust mountings broken, but exhaust secure at time of test.

Parking brake lever has no reserve travel (3.1.6b)

Slight corrosion to OSF inner wing, ok at time of test.

Nearside Front Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Suspension component mounting prescribed area is excessively corroded chassis and inner sill (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

O/S rear tyre has a cut but not deep enough to reach cords

Horn not working (1.6.2a)

Nearside Front brake caliper leaking (3.6.A.1)

O/S rear tyre has a cut but not deep enough to reach cords

Offside front brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing has slight play (2.6.2)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing has slight play (2.6.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing has slight play (2.6.2)

GAS APPLIANCES NOT TESTED ON ANUALL MOT TEST

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe excessively corroded (3.6.B.2c)

gas appliances not tested on anual mot test

Nearside Brake pipe slightly corroded (3.6.B.2c)

Horn not working (1.6.2a)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Service brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Hazard warning tell tale not working correctly (1.4.B.1e)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper blade insecure (8.2.2)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Windscreen wiper blade insecure (8.2.2)

tyres perishing