2005 Fiat Ducato

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Rear Position lamp not working (4.2.1 (a))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Front Upper engine mounting deteriorated resulting in excessive movement (6.1.D.1a)

Nearside Stop lamp not working (1.2.1b)

Offside Front Upper engine mounting deteriorated resulting in excessive movement (6.1.D.1a)

Offside Rear Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Stop lamp not working (1.2.1b)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust hanger detached but system still adequately supported.

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Nearside Front Service brake indicates brake bind (3.7.D.2a)

Nearside Headlamp aim too low (1.8)

Nearside Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded crossmember (2.4.A.3)

Rear Brake load sensing valve seized (3.6.E.3)

Centre Vehicle structure has slight corrosion (6.1.A.1)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Vehicle structure has slight corrosion inner wing (6.1.A.1)

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Nearside Vehicle structure has slight corrosion (6.1.A.1)

Offside Front Vehicle structure has slight corrosion inner wing (6.1.A.1)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Suspension component mounting prescribed area is corroded but not considered excessive sills (2.4.A.3)

Offside Vehicle structure has slight corrosion (6.1.A.1)

Rear Vehicle structure has slight corrosion (6.1.A.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Inner Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too low (1.8)

Rear Brake load sensing valve seized (3.6.E.3)

Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Suspension spring mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre(s) is inadequate for the vehicles maximum permitted laden weight due to an incorrect load index (4.1.B.1b)

Nearside Rear Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Rear Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

front brake application uneven (3.7.B.2)

Nearside Outer Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)