2004 Toyota MR2

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Rear Service brake binding but not excessively (1.2.1 (f))

general underside corrosion

Nearside Rear Inner Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Rear Inner Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear sills (5.3.6 (a) (i))

handbrake leaver close to top

Play in steering rack inner joint(s) ()

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Play in steering rack inner joint(s) ()

Coil spring corroded all 4 (5.3.1 (b) (i))

Front Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Brake performance not tested due to leak (1.2.1 (g))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake hose connection leaking on a hydraulic braking system at caliper (1.1.12 (c) (ii)) DANGEROUS

Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Coil spring corroded all 4 (5.3.1 (b) (i))

Front Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Stop lamp not working both (1.2.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is fractured (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front brake disc excessively pitted (3.5.1h)

Nearside front brake juddering severely (3.7.A.2b)

Offside Front brake disc excessively pitted (3.5.1h)

Offside front brake binding (3.7.B.1)

Offside front brake juddering severely (3.7.A.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Slight corrosion to inner braking surfaces of all brake disc's

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)