2005 Kia Picanto

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Tyre obviously under inflated (5.2.3 (l))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Tyre obviously under inflated (5.2.3 (l))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front tyre worn outer edge

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front tyre worn inner edge

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Front tyre worn outer edge

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front tyre worn inner edge

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Oil leak under engine ()

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Nail in tyre ()

Oil leak ()

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

n/s/front abs rotor cracked

small nicks in sidewall of n/s/front tyre

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)