2006 Peugeot 206

Central Exhaust has a major leak of exhaust gases clamp loose (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering bulk head excessively corroded next to brake servo (6.1.1 (c) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Play in steering rack inner joint(s) ()

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside sill distorted/damaged

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Play in steering rack inner joint(s) ()

Brakes imbalanced across an axle handbrake (3.7.B.5b)

Windscreen wiper does not clear the windscreen effectively split (8.2.2)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Tyre worn close to the legal limit (4.1.E.1)

both front tyers on edges below 1.6mm.

Exhaust system not adequately supported (7.1.1)

Rear fog lamp not working (1.3.2b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)