2005 Fiat Ducato

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe likely to become detached or damaged inner wing (1.1.11 (d) (ii))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Macpherson strut pin or bush excessively worn strut top bearing (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Vehicle structure has slight corrosion (6.1.A.1)

offside strut top bearing stiff

Battery insecure (1.9.1)

Brake load sensing valve seized (3.6.E.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded front (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded inner wing (2.4.A.3)

Offside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Vehicle structure has slight corrosion (6.1.A.1)

offside strut top bearing stiff

Exhaust has a minor leak of exhaust gases (7.1.2)

Vehicle structure has slight corrosion (6.1.A.1)

Centre Rear Stop lamp not working (1.2.1b)

Exhaust system not adequately supported (7.1.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Front Macpherson strut has excessive movement in the upper support bearing assembly sized (2.5.B.1b)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear fog lamp not working (1.3.2b)

Offside Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Rear Suspension component mounting prescribed area is excessively corroded crossmember (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Vehicle structure has slight corrosion (6.1.A.1)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

offside inner sill corroded

Exhaust system not adequately supported (7.1.1)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear position lamp(s) insecure (1.1.A.3a)

Nearside rear brake grabbing severely (3.7.A.5b)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)

Nearside Headlamp aim too high (1.8)

Nearside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside rear brake grabbing severely (3.7.A.5b)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Long handbrake travel

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Rear Brake load sensing valve linkage seized (3.6.E.3)

exhaust leaking at E G R pipe

Spare tyre defective

o/s rear light lens broken