2002 Toyota Corolla

front brake pad sliders faulty

general corrosion

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim too low (1.8)

front brake pad sliders faulty

general corrosion

slight wear in n/s antroll bar

Brake pedal spongy (3.3.B.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Brake hose excessively deteriorated (3.6.B.4d)

brake pads wearing low

slight wear in n/s antroll bar

Offside Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

slight wear at o/s/f antiroll bar link

some imbalance and slight judder at front brakes poss caliper fault

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Headlamp not working on dipped beam (1.7.5a)

front brake pads and discs worn

slight bind at o/s/f brake

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

front brake pads and discs worn

slight bind at o/s/f brake

Drive shaft which forms part of the suspension slightly corroded (2.4.G.4a)

Front Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Fuel pipe/s corroded

Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Shock absorber has slight corrosion to the casing (2.7.2a)

Suspension arm corroded but not seriously weakened (2.4.G.1)

can't check sills fully kit fitted

coil spring corroded (2.4.C.1b)

exhaust system corroded

front brake disc's worn

rear brake disc's scored and pitted slightley

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Drive shaft which forms part of the suspension slightly corroded (2.4.G.4a)

Front Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Fuel pipe/s corroded

Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Shock absorber has slight corrosion to the casing (2.7.2a)

Suspension arm corroded but not seriously weakened (2.4.G.1)

can't check sills fully kit fitted

coil spring corroded (2.4.C.1b)

exhaust system corroded

front brake disc's worn

rear brake disc's scored and pitted slightley

some wear in front brake discs

both rear tyres worn and closs to limit

rear pads low

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

rear tyres wearing uneven

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

rear tyres wearing uneven

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nail in nearside rear tyre