2008 Iveco Daily

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

chassis repair undersealed

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cab members/bulkhead/inner wings (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tubs (5.3.6 (a) (i))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cab members/bulkhead/inner wings (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tubs (5.3.6 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Prop shaft likely to become detached (6.1.7 (a) (ii)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Position lamp showing white light to the rear all lamps (4.2.3 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Outline marker lamp not working (4.2.1 (a))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front tyre sidewall damaged

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

exhaust mounting rubbers split

All position lamps adversely affected by the operation of another lamp only work with headlights (1.1.A.3f)

Horn not working (1.6.2a)

Nearside Body has a sharp edge caused by damage side repeater (6.1.C.1)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front tyre sidewall damaged

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

exhaust mounting rubbers split

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake fluid warning lamp illuminated (3.6.G.2)

Horn not working (1.6.2a)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Offside Registration plate lamp not working (1.1.C.1d)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

nearside rear tyre cracked/perished

Brakes imbalanced across an axle (3.7.B.5b)

Horn not working (1.6.2a)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Side repeater not working (1.4.A.2c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

brake warning light on

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Brake fluid warning lamp illuminated (3.6.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

clutch peddal rubber missing

side markers out