2007 Gilera Runner

Front Lower Panel missing.

Front Position lamp incorrect colour (4.2.3 (a) (i))

Front fork legs show signs of wear

Fuel cap surround incorrectly fitted.

Rear Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Saddle base is cracked but fixing is secure.

V.I .N. stamping on main frame is corroded and difficult to read.

front tyre has uneven wear.

various fairing screws missing.

Front Lower Panel missing.

Front Position lamp incorrect colour (4.2.3 (a) (i))

Front fork legs show signs of wear

Fuel cap surround incorrectly fitted.

Rear Brake component inadequately mounted Rear flexible hose clip missing, replaced at station. (1.1.21 (c))

Rear Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Saddle base is cracked but fixing is secure.

V.I .N. stamping on main frame is corroded and difficult to read.

front tyre has uneven wear.

various fairing screws missing.

Front Brake fluid below minimum mark (1.1.10 (d) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Direction indicator lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Steering headbearing has slight free play (2.2.2 (f) (i))

Steering movement slightly 'notchy' (2.2.1b)

Front Brake hose is likely to be fouled or trapped by moving parts (3.2.B2c)

Front wheel bearings are excessively rough (2.3.5b)

Front wheel bearings have excessive free play (2.3.5b)

Headlamp aim too low (1.6)

Nearside Front Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front Front shock absorber seal failed and leaking oil (2.3.3)

Rear Brake hose is likely to be fouled or trapped by moving parts (3.2.B2c)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Steering movement slightly 'notchy' (2.2.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))