2003 Toyota Yaris

Nearside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Handbrake slight travel

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Weld repairs heavily undersealed making it hard to inspect fully

coolant empty

corrosion Underbody

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength backing sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength backing sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

coolant empty

corrosion Underbody

Coolant leak radiator leaking ()

Front Bumper insecure ()

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive sill back (2.4.A.3)

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive sill back (2.4.A.3)

poor repair to n/s rear valence/back panel

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Lower Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Lower Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Coolant leak radiator leaking ()

Front Bumper insecure ()

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive sill back (2.4.A.3)

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive sill back (2.4.A.3)

poor repair to n/s rear valence/back panel

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (2.4.A.3)

front bumper and inner wing shields insecure

n/s rear tyre perished

slight corrosion /scabs to both sills

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (2.4.A.3)

front bumper and inner wing shields insecure

n/s rear tyre perished

slight corrosion /scabs to both sills

Front bumper insecure

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

both rear tyres slightly perished

Centre Stop lamp not working (1.2.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Oil leak

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Rear position lamp(s) not working (1.1.A.3b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

front tyres close to the limits

n/s shockabsorber damp with oil

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Front drive shaft coupling flexible rubber or fabric coupling unit severely cracked (2.5.C.1d)