2012 Toyota Hilux

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced all inner sill (6.1.1 (c) (i))

Nearside Obligatory mirror missing (3.3 (a))

Nearside Rear Position lamp lens seriously defective lens broken (4.2.1 (b))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced all inner sill (6.1.1 (c) (i))

Offside Rear Body panel corroded and likely to cause injury sharp edge rear wheel arch (6.2.1 (a) (i))

Offside Rear Position lamp lens seriously defective lens broken (4.2.1 (b))

Position lamp not working all position lamps not working (4.2.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Registration plate missing snapped and half missing (0.1 (a))

Offside Rear silencer missing

Nearside Front Obligatory mirror slightly damaged glass cracked (3.3 (b) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Leaf spring fractured (5.3.1 (b) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Front Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Central Rear Stop lamp(s) insecure (4.3.1 (c) (i))

Nearside Front Obligatory mirror slightly damaged glass cracked (3.3 (b) (i))

Nearside Rear Obligatory mirror slightly damaged mirror cracked (3.3 (b) (i))

Nearside Front Headlamp lens seriously defective glass lens tarnished (4.1.1 (b) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp lens seriously defective glass lens tarnished (4.1.1 (b) (ii))

Offside Front Obligatory mirror seriously damaged, affecting the rear view door mirror broken (3.3 (b) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Position lamp lens seriously defective (4.2.1 (b))

Nearside Rear Obligatory mirror slightly damaged mirror cracked (3.3 (b) (i))

Offside Rear handbrake efficiency low

Oil leak, but not excessive both front driveshaft oil seals leaking (8.4.1 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material brake hose to caliper (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material axle pipe (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material axle pipe (1.1.11 (c))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced all chassis (6.1.1 (c) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Bumper insecure (6.1.4 (a) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced all chassis (6.1.1 (c) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively damaged (1.1.11 (c))

Rear Brake pipe excessively corroded on load sensor (1.1.11 (c))

Rear Registration plate inscription illegible (0.1 (b))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake pad(s) wearing thin n/s and o/s front pads [2mm] (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material flexi to load valve (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear fog lamp not working (4.5.1 (a) (ii))

Brake pad(s) wearing thin n/s and o/s front pads [2mm] (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material flexi to load valve (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Brake pipe slightly corroded Both rear outer by cylinders (3.6.B.2c)

Brake pipe slightly corroded both front calliper pipes (3.6.B.2c)

Offside Front brakes slight bind

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Brake performance not tested due to condition of rear brake pipes (3.7.A.1)

Brake pipe excessively corroded both front - rear, by load valve (3.6.B.2c)

Brake pipe slightly corroded Both rear outer by cylinders (3.6.B.2c)

Brake pipe slightly corroded both front calliper pipes (3.6.B.2c)

Offside Front brakes slight bind

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Brake pipe slightly corroded front to rear main feed to load valve (3.6.B.2c)

Offside Front Brake pipe slightly corroded to rear main feed to load valve (3.6.B.2c)

engine and under trays fitted

both rear tyres load rating isnt high enough for designed axle weight not a reason for rejection at time of test