2012 Fiat Ducato

Engine rough on idle

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge Both font inner edges (5.2.3 (e))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn arm rear bush (5.3.4 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill corroded + holed (7.1.1 (a) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn arm rear bush (5.3.4 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill corroded + holed (7.1.1 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides bushes cracked + worn (5.3.4 (a) (i))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. both sides (1.4.2 (a) (i))

Tyre worn close to legal limit/worn on edge both front tyres wearing on inside edges (5.2.3 (e))

engine rough at idle

Nearside Front Play in steering rack inner joint(s)

Nearside Rear Position lamp has a product on the lens or light source which changes the emitted colour (4.2.3 (b) (i))

Offside Front Play in steering rack inner joint(s)

exhaust system is corroded through outer skin

Front Play in steering rack inner joint(s)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part incorrectly routed (3.6.B.4a)

Offside Side repeater incorrect colour (1.4.A.2f)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Front Play in steering rack inner joint(s)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Fuel system component leaking filter (7.2.3)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Axle has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Suspension spring mounting prescribed area is deliberately modified which significantly reduces the original strength outer sill and floor (2.4.A.3)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Headlamp aim too low (1.8)

Offside Rear Axle has inadequate clearance with the bump stop (2.4.A.1a)

Offside Suspension spring mounting prescribed area is deliberately modified which significantly reduces the original strength outer sill and floor (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

cannot see body mounts to see how secure body is

offside and nearside front outer sills modified to weak condition close to seat belts