2013 Iveco Daily

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Side repeater lens defective which has no effect on emitted light missing (4.4.1 (b) (i))

Offside and nearside side marker lens damaged/missing. Park brake efficiency only 16% (offside low)

Oil leak, but not excessive (8.4.1 (a) (i))

2 side markers damaged and 2 not working. NSR brake pad warning wire cut.

Brake fluid warning lamp illuminated (1.1.10 (f))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Rear Outer Nail in tyre ()

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

engine oil leaks, pad sensor wires broken, offside front inner rim damaged, play rear roll bar d bushes, nearside front tyre damaged on outer wall.

Headlamp aim too low offside and nearside. (4.1.2 (a))

Nearside Front Upper All position lamps light intensity significantly reduced (4.2.3 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake inoperative on one side offside and nearside (1.4.1 (a))

Brake pad(s) less than 1.5 mm thick both rear (1.1.13 (a) (ii)) DANGEROUS

engine oil leaks, pad sensor wires broken, offside front inner rim damaged, play rear roll bar d bushes, nearside front tyre damaged on outer wall.

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Headlamp aim too high (1.8)

Offside Rear Registration plate lamp not working (1.1.C.1d)