2001 Ford Focus

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Brake hose bulging under pressure (1.1.12 (d))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (lip to underside) (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (lip to underside) (7.1.1 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords perished to cord (5.2.3 (d) (i))

Windscreen wiper does not clear the windscreen effectively both sides (3.4 (b) (ii))

Front Brake disc in such a condition that it is seriously weakened heavily scored due to pads worn down to metal (1.1.14 (a) (ii)) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick on metal (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Power steering component has slight seepage from a component steering rack area (2.1.5 (a))

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch area (2.4.A.3)

Nearside Rear tyre perished slightly

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch area (2.4.A.3)

Offside Rear tyre perished

rear suspension and subframe corroded

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill and wheel arch area (2.4.A.3)

Nearside Rear tyre badly cracked

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill and wheel arch area (2.4.A.3)

Offside Rear Tyre worn close to the legal limit at 3 mm and badly cracked (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Rear Sub-frame corroded but not seriously weakened and suspension components (2.4.G.1)

engine oil level very low, added 2 liters before test

Parking brake lever has little reserve travel (3.1.6b)

under body seal added under vehicle

Nearside Front Tyre(s) incorrect because tyres fitted to all steerable axle are not of the same structure (4.1.A.2c)

Parking brake lever has little reserve travel (3.1.6b)

under body seal added under vehicle

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Stop lamp not working (1.2.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside rear brake grabbing slightly (3.7.A.5b)

Offside rear brake grabbing slightly (3.7.A.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)